Thread: Model 70 Stock
View Single Post
Old January 13, 2000, 10:49 PM   #4
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Jeffly, , tighten the outer two and use the center one to sort of fine tune. I would never exceed 25inlbs on any guard screws in plain wood. In a partially bedded stock 45-50 inlbs and in a pillar bedded stock up to 65 inlbs. If your rifle is bedded start at about 30 and work up at 5lb increments until you find the tightness that groups best for you. George
George Stringer is offline  
 
Page generated in 0.04096 seconds with 7 queries