View Single Post
Old December 23, 1999, 04:49 PM   #1
average american
Junior Member
 
Join Date: December 13, 1999
Posts: 14
I have a thompson auto ordinance 1911A1 and have recently started experiencing extractor "clocking". The notch for the firing pin stop is too deep for the stop to fully engage it, and the partial rotation of the extractor is causing me jamming problems. Does anyone out there know of a particular brand of aftermarket extractor that has this notch cut shallower than a typical GI extractor so that i can fit it to the stop properly?
As you can imagine, i'd like to get this fixed without having to buy 3 or 4 extractors first. (and a non functioning 1911 is one of life's most annoying problems!!)Any help i could get would be greatly appreciated.
average american is offline  
 
Page generated in 0.04218 seconds with 7 queries