View Single Post
Old November 27, 1999, 08:55 AM   #4
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Kernel, I thought it was only a finish but you never know. The only "bad" possibility of enlarging the hole the way you're planning is the chance of getting it out of round or too big. If you don't have a smith near you take the barrel only down to your local machine shop. They should be able to ream the hole to the specific size you need. George
George Stringer is offline  
 
Page generated in 0.04320 seconds with 7 queries