View Single Post
Old November 9, 1999, 03:04 AM   #2
oberkommando
Senior Member
 
Join Date: September 25, 1999
Posts: 1,157
I replaced one years ago so might not be much help but was in jr high at the time I believe that you only need to remove the 2 screws in butt pad and then nut on end of threaded shaft and the stock should just slide off the long steel threaded shaft. Hope this helps it was back during the cold war last time I looked at one.
oberkommando is offline  
 
Page generated in 0.04084 seconds with 7 queries