View Single Post
Old August 15, 1999, 12:50 PM   #4
sant
Member
 
Join Date: July 4, 1999
Posts: 25
I your Commander a series 80? if so it could be that the firing pin safety is not working correctly. The firing pin might still be locked at the moment the hammer is falling. Try this, make sure the gun is empty ,cock the hammer and push in the firing pin with the tip of a pen it shouldn`t move . Then pull the trigger and lower the hammer slowly the firing pin should release before the hammer is down.
sant is offline  
 
Page generated in 0.04027 seconds with 7 queries