View Single Post
Old July 19, 1999, 06:59 PM   #3
deanf
Senior Member
 
Join Date: June 5, 1999
Location: N47º 12’ x W122º 10'
Posts: 1,598
So, is the 8 round follower just a shorter version of the 7 round follower?

It would appear possible to cut down the 7 round follower so that it can travel further towards the floorplate, thus allowing 8 rounds. The portion to be cut would be the long side that travels down the spine of the mag as the rounds are loaded. Test fitting with 8 rounds with the spring out and the florrplate off indicates exactly 1/8th inch should be removed.

Would someone out there mind comparing the 7 and 8 round followers to see what the difference is?


------------------
“The whole of the Bill (of Rights) is a declaration of the right of the people at large or considered as individuals. ... It establishes some rights of the individual as unalienable and which consequently, no majority has a right to deprive them of.” -Alexander Addison, 1789

[This message has been edited by deanf (edited July 19, 1999).]

[This message has been edited by deanf (edited July 19, 1999).]
deanf is offline  
 
Page generated in 0.07004 seconds with 7 queries