Thread: OAL Variance
View Single Post
Old September 5, 2005, 11:25 PM   #1
beardking
Senior Member
 
Join Date: July 22, 2004
Location: Dallas, TX (area)
Posts: 126
OAL Variance

What do you guys consider an acceptable variance in your loads? I'm loading .40 S&W with 180g Barry's Plated over 4.2g of Titegroup. I have the OAL set for 1.125" per my manual (the multi-manual that you find in the shops with multiple mfg's data all in one book). What I'm getting out varies from 1.122" to 1.126" (mostly 1.124"). Should I accept a variance at all? If so, what is too much of a variance. I've already shot a couple hundred of these this way, but I just wanted to check with others to find out if I'm putting myself in a dangerous situation.

Thanks in advance.

Beardking.
beardking is offline  
 
Page generated in 0.04805 seconds with 7 queries