The Firing Line Forums - View Single Post - Problem seating/crimping 9mm on a Hornady LnL

BigJakeJ1s · September 5, 2005, 09:48 PM

Here is a link to the new dimension die instructions on Hornady's website.

Hope this helps,

Andy

OOPS! Just saw the link also posted earlier... That's what I get for not reading the entire thread first!

September 5, 2005, 09:48 PM	#20
BigJakeJ1s Senior Member Join Date: August 8, 2005 Location: Arlington TX Posts: 650	Here is a link to the new dimension die instructions on Hornady's website. Hope this helps, Andy OOPS! Just saw the link also posted earlier... That's what I get for not reading the entire thread first!