View Single Post
Old September 4, 2005, 07:02 PM   #17
artbyaccident
Member
 
Join Date: July 5, 2005
Location: oregon
Posts: 19
now with the center of the die backed out all the way turn down the die until it just touches the case the maybe back it off 1/4 turn. Now lower the center of the die until it touches the bullet (just the center you dont want to touch the case yet) now press the bullet in a little at a time until you have the correct over all case legnth



now back out the center of the die all the way again

and lower the outside of the die to the case until it touches
artbyaccident is offline  
 
Page generated in 0.05112 seconds with 7 queries