View Single Post
Old June 28, 1999, 01:34 AM   #1
Darthmaum
Senior Member
 
Join Date: June 23, 1999
Posts: 394
I have a SIG P228, and noticed in SIG's catalog recently that the trigger pull can be shortened by "messing with" the little screw (my term.) above the trigger, near the slide release lever.

My ?'s are: Is this advisable? Will it noticeably effect performance? Can it be done by the layperson, and if not, how much could I expect to pay, should I choose to have it done?

Any insight would be appreciated!

------------------
Janet Reno, aka "tertiary adjunct 5 of 12"... "We are BIG BROTHER. Resistance is futile, you will be assimilated..."
Darthmaum is offline  
 
Page generated in 0.04130 seconds with 7 queries