Thread: Barrel Repair
View Single Post
Old March 29, 1999, 07:50 AM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Art, if I read you right the holes don't go through and actually into the bore. I've done the following with several rifles after either drilling & tapping for scopes or if that was done at the factory and the owner just wants the sight screw holes filled in. Buy or make threaded plugs in mild steel about 1/16" longer than necessary. Screw in, pean them down then polish and blue as usual. Very rarely can you even tell they are there. Welding would probably work just fine as well. George
George Stringer is offline  
 
Page generated in 0.04680 seconds with 7 queries