View Single Post
Old January 20, 1999, 07:19 AM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
EricO, the cut for the Novak is 65deg x .495". The cut for the Heinie is 65deg x .370. It might be possible to shim the Heinie base for the extra .125" (1/8") but I think it would be more feasible to solder in a blank to fill the old dovetail slot and recut it. I would think this would run you $60 minimum not including the sight. George
George Stringer is offline  
 
Page generated in 0.05495 seconds with 8 queries