View Single Post
Old November 20, 1998, 05:04 PM   #3
motorep
Senior Member
 
Join Date: October 29, 1998
Location: mid-coast Maine
Posts: 542
I recently went through the same process on an 1100 - used a Dremel, fit the follower, grind, fit the follower, etc. Finally got it to work. The next week, I mentioned this whole process to my gunsmith- he said all you need to do is drill the detents out with a 1/4" drill and smooth up the burrs with the Dremel. He loves guys with Dremel tools.
motorep is offline  
 
Page generated in 0.04070 seconds with 7 queries