View Single Post
Old November 20, 1998, 01:56 AM   #1
Chris
Junior Member
 
Join Date: November 20, 1998
Posts: 5
I just purchased an 870 Express Magnum w/parkerized finish and fiberglass stocks. Also, got a TacStar mag extension (which came w/spring)when I bought the gun. Instructions state that the two small detents inside the tube must be filed down to function. Well, I ground them down w/the handy Dremel. The factory follower still seems to hang up sometimes near the front of the tube when the mag is full and causing a failure to feed. I ground the detents off and I don`t dare take any more metal off from inside the tube. I plan on getting a new high vis follower - are these any smaller in diameter. Anybody have similar problem - any suggestions would be greatly appreciated.
Chris is offline  
 
Page generated in 0.04041 seconds with 7 queries