View Single Post
Old October 28, 1998, 02:27 PM   #1
Steve Koski
Member
 
Join Date: October 19, 1998
Location: Spanish Fork UT, USA
Posts: 86
I've just installed a reduced power spring kit in my Ruger SP101 in 22 LR. I pulled 18 bullets and fired the cases in the gun. All went off.

I believe the risk of lightining hammer springs too much are unreliable ignition. I've also heard that it could cause hang fires. Has anyone actually had a hang fire with a center or rimfire cartridge, or is this a holdover belief from black powder days?

Has any of you had problems after installing reduced power springs into revolvers?
Steve Koski is offline  
 
Page generated in 0.04213 seconds with 7 queries