Thread: Gun Safes
View Single Post
Old July 6, 1999, 09:55 PM   #11
bfoster
Senior Member
 
Join Date: October 13, 1998
Location: N. of Fords Switch, OK, USA
Posts: 297
Lucas... Simple, we used a rollback. It was let down with the regular winch cable doubled back to the headache of the truck with a "snatch" block attached to the safe. This (all but) doubles the working load which the cable can safely handle. We also had chains on the safe which were readjusted every couple feet just in case. It didn't go into the house, but into the garage. It was let down onto 1" cold rolled bar stock, and moved across the cement floor into position with a couple large pry bars. The driver & I did it without other help in less than an hour, though I'd own up to breaking into a sweat.
bfoster is offline  
 
Page generated in 0.04545 seconds with 7 queries