View Single Post
Old June 13, 2005, 08:28 PM   #1
virginia scout
Member
 
Join Date: March 9, 2005
Posts: 22
Question on 9MM loads

I have reloaded Mixed Brass in 9MM with 3.8 grains of titegroup with cci primers and a hornady 124 grain flat point with OAL of 1.050. These are going 1105 measured on a chrony.

When shot out of a taurus 92AF I get a bulge in the primer that looks like it moves the primer back into the bolt face expanding it slightly back into the firing pin champher.

With this light of a load I do not think it is an overpressure sign.

I am going to shoot some factory ammo through it tomorrow to see what they do.

Any thoughtson what might be the cause?
virginia scout is offline  
 
Page generated in 0.04124 seconds with 7 queries