View Single Post
Old June 1, 2005, 01:18 PM   #12
TomNash
Senior Member
 
Join Date: October 4, 2004
Posts: 118
G19 - Sounds like a good setup to me... Didn't read if you have the mold or not, but the FBI standard size is 16" long by 6" by 6" . I used stainless steel for mine and wound up paying $70. I would assume that aluminum would be good too, and much lighter/cheaper. If you are looking to test rifle bullets with more 'juice' than a .308win expanding bullet or a 20 guage, I would suggest having a larger mold fabricated to make a larger block. When the 16x6x6" block was shot by a 12 gauge, it cut the block into almost three pieces. Very dramatic, but not what is needed for any meaningful results. Good luck! Tom
TomNash is offline  
 
Page generated in 0.04744 seconds with 7 queries