Thread: Help needed
View Single Post
Old May 9, 2005, 05:47 PM   #1
300wsm
Junior Member
 
Join Date: April 1, 2005
Location: Wisconsin
Posts: 9
Help needed

Ok heres the situation. Im trying to figure out the bullet seating depth. Im using 150gr. Accubond bullets and nosler says the max. total length should be 2.860 but when i do what nosler says with flattening part of a used case then putting a bullet with perminate marker on the whole bullet. and finding the length when cycling the bullet it is about 2.961 and can't even eject. Im using a browning a-bolt 300WSM white gold medallion. if anyone can give any advice would be great.
andy
300wsm is offline  
 
Page generated in 0.04386 seconds with 7 queries