View Single Post
Old April 26, 2005, 11:58 PM   #6
cuate
Junior member
 
Join Date: February 18, 2005
Location: Comanche Co. Texas
Posts: 737
Neck Sizing Question

I generally do lube the necks especially if the decapping pin/inner sizer is in the die, have had the latter hang in there and a pain to get out. My proceedure is to decap with a die for that purpose, resize the neck down, expand slightly with a die for that. Then the bullet with gas check will barely start in the neck. After powder the seating die and definitly no need to crimp. All this of course with a six holer press. Talking about '06 and 30-40 rifle rounds.
(Lee Dies) Slow but accurate.
cuate is offline  
 
Page generated in 0.04988 seconds with 7 queries