View Single Post
Old October 15, 1999, 11:12 AM   #8
Paul B.
Senior Member
 
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,648
Long Path. When I worked for a gunsmith, many years back now, one of the things I learned from him is torqueing down screws in aluminum. Tighten them down, a little at a time, going back and forth. Wait a couple of hours, and you could get a few more fractions of a turn out of them. I'm pretty sure the screws were properly tightened. I have another 30-30 with a 5D sight on it that I have not shot in several years. If I think about it, I'll dig it out and see where it shoots.
Paul B.
Paul B. is offline  
 
Page generated in 0.04173 seconds with 7 queries