Thread: mixed brass
View Single Post
Old April 8, 2005, 05:58 PM   #1
arrggg
Member
 
Join Date: December 6, 2004
Posts: 22
mixed brass

I have been neck sizing my brass with lee dies, I have fired ~120 without issue, however I just remembered that I picked up a few peices of brass at the range and had put them in the mix with all of my once fired brass from my rifle. Am I doing something dangerous by neck sizing only on the brass that was not fired from my rifle?

I am trimmng them all to length, and I have not had any rounds that were very difficult to chamber. Rifle is a rem 700 .308.
arrggg is offline  
 
Page generated in 0.04241 seconds with 7 queries