View Single Post
Old March 27, 2005, 02:27 PM   #8
jasonc84
Member
 
Join Date: February 28, 2005
Posts: 35
Thanks for the replies. The shells i was using were brand new winchester shells so they were full sized( i ususal only do partial full resizing). I ran them up the resizer just to make sure the neck was completely round. the primers also have raised ring around where the firing pin hits and tiny little dots around the whole primer(this is the case no matter the charge or O.A.L.)

Im still having problems with copper fouling. I brought this up in another thread. Since, I've been using outers foaming bore cleaner which turns blue if it detects copper. I can clean it until copper free and after the next shot copper will be coated on the lans of the rifling. someone suggested Sweet's but i can't find that anywhere but on the internet.
jasonc84 is offline  
 
Page generated in 0.04247 seconds with 7 queries