View Single Post
Old March 17, 2005, 10:53 AM   #5
redhawk41
Senior Member
 
Join Date: February 1, 2005
Location: Red Desert
Posts: 752
hey, thanks guys. good thing i got small containers of the various powders, it sounds like i may have a few more to try out!

the W231 and the 215 gr cast sounds like it should be a pretty good medium target load. i got the W231 to load .45 acp, with the additional benefit of lower velocity .41 mag loads.

Quote:
Lead bullets with these powders really isn't recommended unless they're extremely hard, or have gas checks.
if this because of bore leading? i noticed that my bore was a little harder to clean after using the AA#9 with 215 gr cast.

WESHOOT2, so you had better results with the H110 compared to the W296? i will definitely give the H110 a try for the full house loads.

Quote:
It's only drawback is that it is extremely fine, and can leak through many powder measures.
i have the same problem with the AA#9 in my lee perfect powder measure. i gave up on it and just drop it by hand onto the scale. powder was going EVERYWHERE.
__________________
{thought cloud}
redhawk41 is offline  
 
Page generated in 0.04359 seconds with 7 queries