The Firing Line Forums - View Single Post - Why are my listed .451" bullets all .450" in diameter?

siotwo · February 26, 2005, 10:42 PM

Be sure not to measure with the tips of the calipers.

Check....close the jaws then hold them up to the light to see if any gap is present at the tips.

OR....measure with the tips then at the base of the jaw and see if the measurements differ.

Ron

February 26, 2005, 10:42 PM	#5
siotwo Senior Member Join Date: February 6, 2005 Location: The Woodlands, TX Posts: 218	Be sure not to measure with the tips of the calipers. Check....close the jaws then hold them up to the light to see if any gap is present at the tips. OR....measure with the tips then at the base of the jaw and see if the measurements differ. Ron