View Single Post
Old February 11, 2005, 01:23 AM   #15
mikikanazawa
Senior Member
 
Join Date: September 26, 2004
Posts: 449
Hey Harry, thanks for posting the pic! I envisioned what you were talking about (the ball-nose end mill) but the pic was great confirmation anyway.

Is there a reason you don't use regular centercutting mills to make a square notch? I had the same idea you're using, except with a regular square-cut mill to make the notch bigger, but keeping it "notchy."
mikikanazawa is offline  
 
Page generated in 0.04113 seconds with 7 queries