View Single Post
Old November 27, 2002, 10:45 PM   #8
Blue Duck357
Senior Member
 
Join Date: October 6, 2000
Posts: 1,460
As noted in the first post my 65 is stock. Last checkup during qulification it showed 8#'s of hammer fall which is twice the required spec so there should not be a problem there.

I'm wondering how much of a bad combination Dillon/CCI is as I've never had a problem with Winchester or Federal primers in either gun with the same loading outfit, yet some say they are doing ok with CCI, others (such as myself) are not having very good luck. The Dillon tech I talked to was not at all surprised at the problem but actually only seemed a bit confused as to why they were even feeding very well in the machien as he said a lot were out of spec both height and round wise. Maybe other machiens handle those variables better???
Blue Duck357 is offline  
 
Page generated in 0.04079 seconds with 7 queries