View Single Post
Old October 1, 1999, 08:19 PM   #1
Bennett Richards
Senior Member
 
Join Date: November 14, 1998
Location: Carlsbad, CA USA
Posts: 343
I just brought home my new 870 Marine Mag and 3when I broke it down I noticed 2 strange things.
1. When I unscrewed the Magazine extension tube and removed the spring, the follower didn't just fall out when I turned the weapon upside down, it was stuck near the end of the mag tube about about 3/4's of an inch below where the threading starts. I stuck some shells into the Mag until they reached the follower then it and the shells fell out. It is snug at that spot. Has anyone else noticed this with their 870 marine? There do not appear to be any dents or rough spots on the inside of the tube...

2. When I turn the assembled weapon upside-down and then rightside up I somnetimes hear the sound from inside the weapon like a washer sliding down a long bolt. It is NOT in the MAG tube, and I can't see anything inside the receiver that might make this noise. Anyone else with the 870 Black synthetic stocks hear this?

Thanks,

Ben
Bennett Richards is offline  
 
Page generated in 0.04976 seconds with 7 queries