View Single Post
Old June 28, 2002, 12:28 AM   #6
David Wile
Senior Member
 
Join Date: June 14, 2001
Location: Mechanicsburg, PA
Posts: 582
Hey folks,

I've had my Lyman furnace for a dozen or more years, and I have never had the bottom spout "freeze" until after I pulled the plug and let it all cool down. When casting, it is a continuous process for me, but there are times when I let the pot sit for five to ten minutes while I change moulds on handles, and I still do not get a "freeze" as you have described. Then again, I keep the temperature quite hot for my casting - hotter than what is usually recommended.

Best wishes,
Dave Wile
David Wile is offline  
 
Page generated in 0.04856 seconds with 7 queries