anubis
November 21, 2001, 01:32 PM
Purchased an oversized safety for Benelli, and in attempting to install it, managed to dislodge the small wire spring on the right side of the trigger group, without first looking carefully to see where it was connected !!
It is held in place by one of the two trigger assembly pins, which goes thru the coils, but I am unsure where the long end goes now.
While I'm at it, does anyone know how to remove the existing safety, so I can replace with the oversized unit ?
Some advice, or an exploded diagram, sure would help.
Thanks,
It is held in place by one of the two trigger assembly pins, which goes thru the coils, but I am unsure where the long end goes now.
While I'm at it, does anyone know how to remove the existing safety, so I can replace with the oversized unit ?
Some advice, or an exploded diagram, sure would help.
Thanks,