PDA

View Full Version : Portable target stand


1-DAB
February 7, 2013, 06:48 PM
made this this afternoon, base is 18x36, middle section is also 18x36, and top is 18x24, all 3/4" plywood, cut to 3" wide and joined with pocket screws. some smaller pieces cut to 4" long for the brackets on the base and between the top and middle sections. still need to add cardboard to top section. no tools needed to put together or take apart, should fit in most any trunk.

http://i937.photobucket.com/albums/ad214/brinkmancorvette/09BFF0D4-BC71-48D6-BA40-8703476BF0D7-24712-00003EAFDE02A60F_zps796c9d8d.jpg

redrick
February 7, 2013, 09:47 PM
I made one out of pvc. I got the idea off of youtube. It took me about 5 mins. to make.

gundog5
February 8, 2013, 01:23 PM
Nice stand:)

nazshooter
February 8, 2013, 03:22 PM
Thanks for posting that. I normally use campaign signs but I've run out and really need to make something up.

Sent from my ADR6425LVW using Tapatalk 2

Babyfacenelson
February 8, 2013, 04:02 PM
Well done!
I also use those campaign signs a lot, i keep shooting through the wires though, i may to need rethink where i tape up the target sheets :rolleyes: