PDA

View Full Version : Win 670


Wildman1960
November 13, 2012, 10:55 AM
Anybody know where to get a trigger guard and screws for a Winchester 670, have exhausted all the usual parts houses, any suggestions will be appreciated.

Doyle
November 13, 2012, 11:19 AM
The guard and screws from the same year Model 70 should also fit. The difference between the Model 70 and 670 was finish and stock quality.

Wildman1960
November 13, 2012, 04:15 PM
Thanks a million Doyle

oneoldsap
November 13, 2012, 07:40 PM
The 670 has a blind magazine whereas most M70s are of the drop floorplate varity . Might be a good time to upgrade your 670 to bottom metal and an M70 stock !

PetahW
November 14, 2012, 05:25 PM
Actually, the issue M670 stock will accept the Model 70 TG w/floorplate, magazine liner, etc.
IIRC, the follower & spring you now have should fit/work OK.

Just run a small drill(bit) down/out through all four corners of the blind magazine well, then cut out between the holes & clean up to get straight/tapering lines that match the M70 bottom metal.

The bottom of the stock just ahead & behind the new magazine opening will also need to be inletted for the bottom metal.

(I've added the upgrade to both Win 670's and old Rem 700 ADL's, both using new factory parts from the respective Parts Dept's)

.

jmr40
November 14, 2012, 06:48 PM
It won't be cheap, but you can contact these guys

http://williamsfirearms.com/triggerguard.html


Found one here.

http://www.gunpartscorp.com/Products/1296220.htm