PDA

View Full Version : can anyone id these?


E Rob
September 17, 2012, 11:25 AM
Got a big collection of grips and parts, these look military

tahunua001
September 17, 2012, 11:34 AM
I've never seen anything like them. do they have any inspectors proofs or cartouches?

meatgrinder42
September 17, 2012, 12:14 PM
Cetme or g3 hand guards.

tahunua001
September 17, 2012, 12:25 PM
cetmes and g3s had wood handguards? I guess I learned something today.

Chuckusaret
September 17, 2012, 12:38 PM
Yes they did have wooden handguards semilar to the ones in the picture.

m&p45acp10+1
September 17, 2012, 02:12 PM
They look like hand guards for a .30 Carbine. There were several variants made during WWII. Also some of the Plainfield models, and some of the transitional Iver Johnson carbines had hand guards that looked like those. They were easier to carve out of wood, and cheaper to produce. Some did have metal perforated hand guards though they were the early models made with surplus parts, and later models made went back to metal on some of the models.

E Rob
September 17, 2012, 03:33 PM
No proofs or stampings. They are both 11 3/4 in. long but not the same number of perforations and the ends are not quite the same but they would go on the same firearm, they have been around for some time but I would say they have never been on a gun as they are in mint con.

E Rob
September 17, 2012, 03:59 PM
These are some of the grips that were in the collection, there are 20 more pair that are not in the pics and they are all in exc. con. The bipod is stamped U.S. W.M.1. bipod rifle M2. All this and more was from an estate that I lucked into, the kind you like to luck into you know.

m&p45acp10+1
September 17, 2012, 05:48 PM
If they are 11&3/4 inches long then they are more than likely hand guards for M1 Garrand not carbine. The carbine hand guards are about 6 inches long.

In the picture in the above post it looks like an assortment of K and J frame grips. The smaller shorter ones are for J frames. The larger for K or N frame models. The top far right looks like wood grip panels for a 1911 frame. The square set on the bottom I am unsure of possibly for a S&W semi auto. Or a Sig Sauer.

Jo6pak
September 17, 2012, 06:16 PM
The bipod is for a M14/M1A

E Rob
September 17, 2012, 06:58 PM
thanks for imfo on bipod and the others, just wanted to share some pics

Chuckusaret
September 18, 2012, 09:30 AM
googled CTME rifle

Que
September 18, 2012, 04:21 PM
CETME. I own a number of them. The G3 that I have are a bit different.

Now that I look at it again one is CETME and the other HK G3. On the G3 the cut out area under where the cocking handle would be cinches it

madcratebuilder
September 19, 2012, 07:57 AM
A quick look at Gunbroker well tell you they are CETME & G3. The bi-pod sounds like a real GI issue bi-pod, can be spendy.

http://i32.photobucket.com/albums/d37/madcratebuilder/M1A/m2bipod2.jpg