View Full Version : Long lasting lubrication and corrosion protection
March 14, 2012, 08:24 PM
What is your favorite long lasting lubrication and corrosion protection for bores?? Mainly for never fired in display BP revolvers.
March 14, 2012, 08:40 PM
Mainly for never fired in display BP revolvers.
Never had one of those. They all get fired. Bore Butter seems to work ok but I dunno how it would be on a permanent basis.
March 14, 2012, 10:05 PM
I use RemOil for any of mine, fired and unfired. The unfired ones get a good heavy re-oiling with it at least every 4 months. I don't know how long you could actually go without reapplying. I guess it would depend on where you kept them. (humidity and temp variances)
March 14, 2012, 10:11 PM
Never ever to be fired? Use Renaissance Wax. PH neutral, it is used by museum conservators worldwide.
March 14, 2012, 10:56 PM
March 14, 2012, 11:31 PM
Rigs Gun Grease, but the gun will be a lot happier if you shot it, clean it then use Rigs.
March 15, 2012, 12:11 AM
Eezox is well known for being one of the best rust protectants.
Applying a thin film of it will prevent rust like no petroleum oil can.
It's also compatible with black powder, and at less than $7 per container it's relatively inexpensive.
Guns may need to be wiped down with it once a year.
EEZOX® weighs 10.42 pounds per gallon - squirt or spray EEZOX® into a container of water and it will sink to the bottom. This density prevents water from penetrating the thin layer of EEZOX® and from reacting with the metal to form rust. Because of the hydrocarbon oil content of other products, they will "float" on water. Therefore, water penetrates this oil layer and rests on the metal surface. The water then reacts with oxygen and the metal surface to form rust.
Our research clearly shows over 75% of gun owners are not satisfied with gun care products presently being used. Compare this to the 98.7% of EEZOX® users who are greatly satisfied.
March 15, 2012, 12:30 AM
dare i say it<<<<<<<<<<<<<...... COSMOLINE :D Worked good storing Mil Surps 70 years old haha
March 15, 2012, 04:18 AM
I use RemOil for any of mine, fired and unfired.
If you don't clean it out of the bore and chambers before you shoot it you're making the cleaning job afterwards harder.
March 15, 2012, 06:22 AM
Birchwood Casey's Barricade.
BP compatible, easy to apply, works for long term storage.
Although if the intent really is just long term display, 4v50Gary's mention of Renaissance Wax is the best answer.
vBulletin® v3.8.7, Copyright ©2000-2017, vBulletin Solutions, Inc.