PDA

View Full Version : Question


LAH
February 21, 2012, 01:34 PM
Can you name them?

http://i66.photobucket.com/albums/h244/Creekerpics/Loading%20Room%20101/Bullets/DSC02442.jpg

parttime
February 21, 2012, 04:31 PM
BOOLITS

LAH
February 21, 2012, 08:51 PM
The left boolit came from this mould, a Lyman 45.

http://i66.photobucket.com/albums/h244/Creekerpics/Loading%20Room%20101/Bullets/DSC02433.jpg

http://i66.photobucket.com/albums/h244/Creekerpics/Loading%20Room%20101/Bullets/DSC02432.jpg

Vance
February 21, 2012, 09:27 PM
fourth to the right looks like my 360160 double crimp groove SWC.

10 Spot Terminator
February 21, 2012, 11:03 PM
I'll take a stab at the 4th to the right as it looks like my 358156 double crimp groove from Lyman, the middle one a Lyman 358431 .

Vance
February 21, 2012, 11:19 PM
Since my NOE 360160 Double Crimp Groove SWC is copied from the Lyman design, either one will do.

LAH
February 22, 2012, 08:23 AM
Thanks for the reply. The 4th bullet [L to R] is the Lyman 358156. The middle [third] bullet is the Lyman 358429.

Vance is your 360160 double crimp groove SWC a copy of the Lyman 358156 with the gas check shank bored to bullet diameter?

IllinoisCoyoteHunter
February 22, 2012, 08:52 AM
Vance is your 360160 double crimp groove SWC a copy of the Lyman 358156 with the gas check shank bored to bullet diameter?

The answer to this question is yes. I have a 5 cavity and it rocks. The group buy started over on CastBoolits allowed for a plain based or gas check shank. Also, we made the lube groove a touch bigger for more lube. If I remember correctly I think I started that group buy a little more than one year ago.

LAH
February 22, 2012, 08:59 AM
Like this:

http://i69.photobucket.com/albums/i80/swedenelson/1111-146360160GrSWCPB.jpg

IllinoisCoyoteHunter
February 22, 2012, 09:04 AM
Yes. Did you get that off cast boolits? Our design was ato drop at .360"

Nevermind. I just looked it up and noticed it is at 361. Mine drops at 360.

LAH
February 22, 2012, 09:05 AM
Yes I copied it from the group buy thread. That's got to be a great bullet.

Vance
February 22, 2012, 09:52 AM
Mine drop at .360 and 162 grains using range lead. The gas check shank measures .341 on mine. It shoots awesome. Didn't have to fiddle with load developement very much. Shoot mine out of a GP100.

IllinoisCoyoteHunter
February 22, 2012, 11:22 AM
Yup. great boolit!

richfr
February 22, 2012, 02:50 PM
I have just got the NOE 360160 Double Crimp Groove SWC 4 cav but in plain base. Not used it yet (my first mould) but hope it will be a good one :)

LAH
February 22, 2012, 06:20 PM
The ones I have from Mr. Nelson are great.