View Full Version : MAK 90 front sight
January 16, 2012, 03:43 PM
The front pin on my front sight will not move even after heating it. Any suggestions would be great appreciated.
January 23, 2012, 12:37 PM
IF I remember right... If Looking down the barrel, Pin drift is left to right.
It is a tapered pin. I will look tonight.
January 23, 2012, 10:23 PM
Apply some Kroil to the drum and let soak 24 hours.
Pick a socket from a socket set that will fit over the sight drum.
Put some sheet brass over the other side of the drum to protect the finish.
Put it in a vise making sure the socket is over the drum and the brass is protecting the other side and tighten the vise to press the drum over.
If the drum requires so much movement that the drum is level with the sight base, put a socket with a small end that's smaller than the drum on that side.
January 24, 2012, 10:45 AM
Oh Heck, Are you adjusting your windage? I thought you
were trying to take the sight off the barrel.
vBulletin® v3.8.7, Copyright ©2000-2014, vBulletin Solutions, Inc.