PDA

View Full Version : Mosin help needed


waymore
September 22, 2011, 08:04 PM
I'm scared I may have really damaged my gun. Just received my Mosin Nagant on monday took it apart cleaned it and put it together, everything looked clean and was working fine. Took the gun to range on Wednesday shot about 40 rds and brought it home took apart and cleaned it. I noticed today when I picked it up that the trigger is just dangling loose. I cant even remove the bolt because I cant depress the trigger to remove it. I also cant remove the barrel because the bolt covers the screw.

Could I havbe damaged the gun by opening the bolt and closing it to work the grease in? Does anyone know how I can fix this?

Thanks

LJ-MosinFreak-Buck
September 23, 2011, 12:10 AM
You're problem is you lost the trigger pin if I'm not mistaken. It's easy to do, the pins are only held in there by the stock.

nyc71
September 23, 2011, 01:56 AM
I misplaced the trigger pin on my initial cleaning too.


"They who can give up essential liberty to obtain a little temporary safety, deserve neither liberty nor safety"- Benjamin Franklin

mxracr
September 23, 2011, 02:10 AM
I did that on my first cleaning as well. Found one on Ebay.

michael m
September 23, 2011, 07:44 AM
Almost lost one on a carbine I use to own. I put it back in then took a punch and made a light punch mark one on each side of the pin. This kept it from happing again.

ducote32
September 23, 2011, 08:24 AM
Did the same thing last night with my Mosin I just purchased. Started cleaning in one place, moved to another to soak it and then say the trigger dangling. It took 45 minutes to find it in carpetw

Check wher you had it apart, like the previous poster said, it will only come out when the stock is off of it.

LJ-MosinFreak-Buck
September 23, 2011, 05:18 PM
If you need a replacement... Click Here (http://https://www.buymilsurp.com/trigger-pin-mosin-nagant-rifles-p-6.html)

waymore
September 23, 2011, 06:37 PM
ok good I just found a little pin on the carpet. how do I replace this? does the barrel need to come off. I can't figure out how to unscrew the screw without taking off the bolt.

LJ-MosinFreak-Buck
September 23, 2011, 06:52 PM
Open bolt, pull down on the trigger (may be a little hard but you gotta pull) then pull the bolt out, and disassemble from there.

LJ-MosinFreak-Buck
September 23, 2011, 06:59 PM
The barrelled action does need to come out of the stock to put this pin back in.

waymore
September 24, 2011, 09:22 AM
got her all bac together again :)

made me nervous as heck pulling on that bolt but it finally came off.

thanks for the help.

LJ-MosinFreak-Buck
September 24, 2011, 10:24 AM
The rifles are practically a dime a dozen, parts are cheap, but if you don't wanna fix toss and buy another! lol:D

Glad you got it back together. And you're welcome for the help.

Plus, I doubt you'd break anything, they're tough guns.