PDA

View Full Version : AMT automag 3


mike72
May 23, 2011, 03:56 PM
I got this pistol and it was missing parts. I ordered some parts that where missing but I dont know I got them all. I cant get any real good info on this pistol. Also I cant figure out how the disconnector spring connects to the disconnector.

GURU1911
May 23, 2011, 05:44 PM
Contact either one of these guys & they should be able to help you:

1. Alex hamilton @ 10-ring precision, san antonio, texas
2. Teddy jacobson @ actions by-t, sugarland, texas

tell them michael in sealy, texas referred you to contact them.

HeroHog
May 24, 2011, 01:33 PM
Here is a little help for ya...
This is for a 9mm WinMag version but they are the same as the .30 Carbine except for the barrel I believe.

http://herohog.com/Guns/9mmWinMag/

Loader9
May 24, 2011, 02:18 PM
Maybe this will help
http://www.glossover.co.uk/amt/pdf/AutoMagIII.pdf

It's the owners manual with an exploded view of the parts. I think you might want to know that these pistols are EXTREMELY picky about the length of the brass. DO NOT cut any of it shorter than max length or expect failures to fire. I've dialed in accuracy by OAL and using pistol primers. H110 works best in mine. If you haven't fired one of these yet, expect major muzzle blast.

mike72
May 26, 2011, 08:47 PM
I have found most of the parts online. I did find that one of the holes that the screws to hold the grips on is stripped out. Someone has tried to put a larger screw in. How could the screw hole be fixed?

HeroHog
May 27, 2011, 10:03 AM
Ues, either with an insert or a helicoil.

jeffhclark
December 15, 2011, 03:19 PM
Here is a quick scetch