PDA

View Full Version : Pillar Bedding


bighead46
May 19, 2011, 12:20 PM
I am sort of confused, maybe somebody can help. In pillar bedding you re-drill the action screw holes in the stock so the holes are big enough to put in the pillars- which get epoxy glued in place. There is supposed to be space around the action screw/bolts so they don't touch the inside of the pillars. It would seem if the pillar could move around very much it could get off center so the screw is touching it. If the pillar fits really tight in the hole then is there enough epoxy to hold it? Also what if the pillar is longer than the stock- just file it down to fit?
And, do you glass bed and put in the pillars all at the same time or do one first, such as first glass bed and then the pillars, or the reverse?

Thanks.

GURU1911
May 19, 2011, 01:44 PM
Guru1911 here !!!!!

Scroll down in this section of the forum & ready the discussion i began & shared with other readers. Hopefully it will answer some of your questions regarding pillar bedding. If you wish to contact me via "pm"---please list your questions numerically and very concise & to the point.

GURU1911
May 27, 2011, 02:44 PM
Have you had an opportunity to read the thread posting i suggested you read ???

Have all your questions regarding pillar bedding been resolved ???

If not, i am still willing to assist you in anyway i can.

Guru1911

GURU1911
June 4, 2011, 01:07 PM
One more time:

Why have you not contacted me ???? My offer to help with your pillar bedding questions is still lying on the table. Please contact me asap if you are still searching for answers.