PDA

View Full Version : Reassembly Winchester Model 1400 Mk II


jells
March 22, 2011, 09:43 AM
I bought a Winchester Model 1400 Mk II at an auction. Before firing it, I started to take down the gun, starting at the trigger group. It was grody and I decided to take it down completely and it's clean.

I can not find a detailed reference to help me with the safety buttom and the sear assy. The hammer spring is in the slot but the safety may/may not operate. I'm tired of removing/installing the pin through the hammer spring support.

The sear assy took flight while removing the disconnector and I just need to know where the loop at the end of sear spring goes and the orientation of the spring behind the disconnector.

Any help will be appreciated.

setfreejoe
November 28, 2011, 05:51 PM
Did you ever get your answer? I am having the same problem although I believe I fixed it but wanted to make sure. Also any issue with the bolt not sliding back after you put the trigger group back in?

trex1310
December 5, 2011, 10:25 PM
You might try this:
http://www.gunpartscorp.com/catalog/Detail.aspx?pid=PDF0526&catid=7434