PDA

View Full Version : SP101 trigger problem help


camsdaddy
December 25, 2010, 10:12 PM
I have a SP101. The gun was functioning prior to tinkering (imagine that) I took it apart to install a Wolf spring kit. I got it all put back together and it and the trigger would not pull back. I took it apart and followed the reinstallation steps as well as I could understand. It will cycle a few times then it wont then it will. I reinstalled everything without the pawl installed and it pulls fine. I am wondering if there is something simple to watch for or change. I am installing the trigger group with the transfer bar and the pawl straight up. When it does cycle its mighty smooth. I will be grateful for any help.

JohnKSa
December 25, 2010, 10:32 PM
If the trigger return spring from the spring kit you installed is too light it may not have enough oomph to fully reset the trigger each time. That will cause the trigger to appear to lock up.

camsdaddy
December 25, 2010, 10:34 PM
I think I have found I was missing the plunger and spring that hold the pawl.