View Full Version : Who does square-to-round butt S&W revolver conversions?
June 12, 2010, 08:20 AM
I'm thinking of sending a few of my already-in-need-of-refinish Model 19s off for conversion to round butt configuration. Recommendations for who to use for the conversion would be appreciated....
Any downsides to doing the conversion?
June 13, 2010, 09:51 AM
Better to look for a round butt 19 nd keep your square buut 19 original
June 13, 2010, 02:17 PM
I appreciate your willingness to share your opinion, but sadly it did nothing to answer my question. ;)
June 13, 2010, 03:05 PM
Try WWW.Gunsmiths.com & search for pistolsmiths near your zip code. It is a fairly easy job, unless the Serial # is stamped in a place that may require it's removal & re-stamping (I had this happen once). Also, note that while removal & re-stamping a Serial # maybe permitted by the BATFE (If done to their specs), it may not be legal in your state. It is not just firearms laws that impact this as some Consumer Protection Laws make it a crime to remove any manufacturer's original markings.
vBulletin® v3.8.7, Copyright ©2000-2016, vBulletin Solutions, Inc.