PDA

View Full Version : savage/stevens 200 safety question


greg1953
January 27, 2010, 08:14 PM
does anyone know if the safety on a savage/stevens 200 is a trigger block or sear block??

thanks in advance 1953greg

maybe i should ask trigger block or hammer block?

greg1953
January 27, 2010, 11:35 PM
bump

Buzzcook
January 27, 2010, 11:52 PM
Trigger block iirc.

greg1953
January 28, 2010, 12:26 AM
thats what i thought and afraid of. the trigger was horrible and i have worked on it and have it down to bout 3lbs w/ no creep. but im not sure if that is safe since the safety is only trigger block.
guess i wil just have to keep the chamber empty, hu?

thanks buzz

rickdavis81
January 28, 2010, 03:41 AM
It is a trigger block. I've adjusted a couple down to the 3lb's with no problems. Did you replace the trigger spring with smaller gauge music wire and just clean up the services, maybe stone some off of the sear to do away with the creep? I'd cock it on an empty chamber and bounce the butt pad off the floor and see if it goes off. Should be safe though.

greg1953
January 28, 2010, 08:49 PM
didnt replace the spring. just reduced the sear engagement with file and lightened the spring tension adjustment screw. it had a heck of a lot of travel before. pretty simple fix. ive banged it around a bit w/o problem.