PDA

View Full Version : Ejection Issue


Dan31
December 28, 2009, 09:45 PM
I inherited a Marlin Lever action .22 made back in the 60's I think. Its in like new condition like the other 7 or so guns we [my brother and I] inherited from my uncle.

The issue is, that after firing a round it seems to jam in the port. I cleaned it very thoroughly before and after use but to no avail. We fired it less than 5 times with it getting stuck. My brother took it home and if I knew about what it might need I can tell him when he takes it to a smith.

Malamute
December 29, 2009, 12:34 AM
The ejector has a small grooved screw that can be used to hold it out of the way to clean from the back. Is the ejector free to move, or is it captured by the screw? Just a slight turn of the screw should free the ejector up if thats the case.

salvadore
December 29, 2009, 01:12 AM
there is a guide, piece of metal secured to the inside top of the reciever attached with a screw from the outside top of the reciever small thin with a hole at one end. cartridge guide spring and screw here.http://www.e-gunparts.com/products_new.asp?CatID=640. If this is not present, cartridge does not feed.