PDA

View Full Version : FS 1858 Remmy 45 LC conversion


tatso7
December 6, 2009, 12:43 PM
Cleaning up the cabinet and need to let go some of the treasures. I fired this gun only ten times with 45 LC cowboy, cleaned, oiled and stored. I have a similar setup in stainless steel so this one has to go. The smeared like appearance on the gun surface is due to the oil reflection.

1858 Remmy ( no BP cylinder )
45 LC conversion cylinder
Slim Jim Holster
Belt.

To your door for $415. Thank you.

tatso7
December 6, 2009, 12:45 PM
more photos...

ClemBert
December 6, 2009, 02:19 PM
Hate to be a Scrooge but don't let that FFL transfer requirement bite you. This appears to be a class 1 firearm and not a cap-n-ball revolver so "your door" may in fact be "your FFL dealer's door".

long rider
December 6, 2009, 03:04 PM
tatso put it on the buy and sell forum.:rolleyes:

noelf2
December 6, 2009, 09:10 PM
Clembert is right. Make sure you follow your state and the federal requirements with this revolver. This is no longer a C&B revolver unless you can find a C&B cylinder for it (or perhaps just don't sell it with the conversion cylinder in it). Sell that R&D cylinder separate, even if you sell it to the same buyer.

tatso7
December 7, 2009, 11:25 AM
Clembert and Noelf2 - Thanks for the advice. You guys are right. I will have to rephrase the contents of my ad.

Long Rider - I intended to post this at the ad section. For some reason it ends up here. :(

Moderator - Please delete this thread. I will repost this at the appropriate section after revision of its contents. Thank you.