PDA

View Full Version : General G3 Mag Questions


wing12345
May 6, 2009, 07:16 PM
Just recently purchased a few used aluminum G3 mags for a future PTR-91 purchase and came across some questions:

1) What do you do when you clean out your mags (meaning what solvents do you use and what parts do you normally clean)?

2) Where can I get replacement springs for G3 mags? How about replacement floor plates for the mags themselves?

(yes I know the mags themselves are pretty cheap to get used right now but in case a fed ban comes around it would be easier to replace broken parts)

Well that's all I have for now. Thanks.