Need Help!

[hunterpoehler22]

I need help reassembling a winchester 1300 I just purchased from a friend. I just need to put all the trigger parts together and then I should be fine. Any help or tips would be greatly appreciated thanks!

[hunterpoehler22]

Pics or videos would help alot too

[porrpk]

http://pdf.textfiles.com/manuals/FIREARMS/winchester_1300.pdf

trigger assembly jpg...

http://www.schiessen-erzgebirge.de/Blueprints/winchester1300_0001.jpg

hope that helps. google winchester 1300 trigger assembly (images)

similar thread....

http://www.ar15.com/forums/topic.html?b=1&f=5&t=861208

-porrpk

[hunterpoehler22]

Ive looked at all of those and still no luck...I just cant figure out how to get all the parts of the trigger group back together. I can get most but I dont understand how the hammer/spring/trigger release/spring go in

[porrpk]

maybe take a look at some other triggers, that may give you some insight. You may need to go to a smith....

check to make sure you have ALL the parts needed first, you may have misplaced one, and that could be your problem. Most triggers are relatively 'logical'. take it slow and think about the physical nature of what the parts are doing and that may help. post some pics of where you are running into difficulty and I'll bet some knowledgable folks out there who own a win 1300 can pipe in with some advice.

-porrpk

[hunterpoehler22]

Anybody with a winchester 1300 mind snapping some pics of your trigger group from all angles and posting them...maybe that will help. Possibly try and get a close up of the hammer and trigger release thanks!

[LordofWar]

I would advise taking it to a gunsmith before you go wrong.

[hunterpoehler22]

The problem is I dont really have the money to take it to a gunsmith