PDA

View Full Version : sig p239 slide rattles


bolt face
April 9, 2009, 07:25 PM
Hi everyone,

Is .015 difference between frame and slide too much on a brand new Sig p239? Any info would be appreciated.

Thanks.

SigfanTN
April 12, 2009, 08:05 PM
I don't think it's a problem. I haven't measured mine with calipers, but it's not really supposed to be a tight fit. This contributes to the famous Sig reliability, especially when dirty. Mine rattles just a bit also, but only when you try to get it to.

Tom2
April 15, 2009, 04:30 PM
Mine rattles worse than an old 45 Colt but it plays OK. Must have had some problems converting from metric to English specs or something.

Clemson
April 18, 2009, 01:32 PM
I bought one in .40 cal about 3 months ago. It is tight as a drum. No rattles at all. So rar about 300 rounds downrange with no failures, so I don't think it is negatively affected by the close fit.

Clemson

Tom2
April 18, 2009, 02:16 PM
Sigs are supposed to be the Cadillac of pistols, though, so it ought not rattle like a rusty old pickup truck going over speed bumps!