PDA

View Full Version : Bore Tech Eliminator


butta9999
October 1, 2008, 03:11 AM
Does anybody use this solvent?
Is it any good?
Do you have to use a powder solvent before it like hoppes 9?

butta9999
October 2, 2008, 05:36 AM
Has nobody heard of this solvent?

johnbt
October 2, 2008, 08:05 AM
I've read about it, but it's one of the few I've not tried. Here's a lengthy review that liked it and he used a bore scope to observe the cleaning process.

www.slip2000.no/Precision%20Shooting%20Magazine%20-%20January%20-%202006%20(Vol.%2053%20-%20No.%209).pdf

John

Bogie
October 2, 2008, 08:53 AM
Some folks like it... Personally, I stick with Butch's Bore Shine...

It's got a nice penetrator, it works good on the carbon, and it has just enough ammonia to work well. And Butch was a nice guy.

johnbt
October 2, 2008, 07:25 PM
Me too.

JT

50 shooter
October 3, 2008, 03:27 PM
I use Eliminator, it's one of the best kept secrets kinda. It doesn't use ammonia so you can use it in doors. It will attack carbon but it's better suited to attack copper. Once you apply it in your barrel, let it sit for a few minutes and then scrub it will a brush. Run a jag through your barrel from the breach end or at least a tight fitting patch to remove all the crud, repeat as needed.

If you read the article you'll notice that copper and carbon can build up in layers. Using a copper solvent and a carbon cleaner together will be the best way to insure that you remove everything.

butta9999
October 3, 2008, 10:45 PM
cheers guys ill look into it, i am just not satisfied with my cleaning products at the moment.

Walkalong
October 9, 2008, 05:07 PM
It is great stuff. Removes copper great with out ammonia.

Chui
October 19, 2008, 06:27 PM
PHENOMENAL product. Nothing compares to it. I recommend it without reservation.

butta9999
October 20, 2008, 02:39 AM
Thats nice to know. Do you use a powder solvent first?

Norman
October 20, 2008, 10:57 AM
Great product. Have been using it for three years. I use it at the range to remove copper. When I get home I clean the barrel with Wipe Out Foam Bore Cleaner. Another great product. Neither of these bore cleaners have ammonia in them and they don't stink.

Chui
October 20, 2008, 05:43 PM
I do use the powder solvent first as the copper directly contacts the lands and the products of combustion is layered on top of the copper.

butta9999
October 21, 2008, 02:06 AM
Great news guys, thanks for replying to an old thread. I use Sweets but am not happy with its performance. Ill have to see if they stock the eliminator in Australia.