View Full Version : replacing ejector spring Ruger SRH
July 21, 2008, 01:11 PM
does anyone know how to replace the ejector spring in the cylinder of a ruger SRH? I know that the ejector retainer is not to be removed. Thnx
July 21, 2008, 07:33 PM
When I worked for Novaks they had a SRH that had been taken apart & couldn't get it back together. They sent it out to me and I finally got it back together.
To be honest, I had one awful job doing it and I seem to remember I had to make a special screwdriver to do the crane/cyl assy.
I really think you would be better off to box it up and send it to Ruger - I doubt if they'd even charge you.
Hugh G Rection
July 21, 2008, 10:49 PM
Not to be a smart aleck, but that may be something that you send back to Ruger for their kind attention.
July 22, 2008, 02:36 PM
thanks gentlemen, I think it is good advice. So far, no damage has been done, I was hoping to have it ready for an elk hunt this October. We'll see.
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.